Meshify Leak & Freeze Sensor

Meshify Leak Sensor

Install Guide

Step 1: Remove Cover

While at the location you intend to place the sensor, remove the battery cover from the sensor.

Step 2: Pull Battery Tab

Pull the tab from the battery and the Meshify Leak & Freeze Sensor will begin searching for cellular signal. Within 5-10 seconds, the LED indicator will blink to signal successful connection to the network and turn off. If the LED blinks red or does not turn on at all, visit the FAQ section below for troubleshooting.

Step 3: Place Device

Replace the battery cover and press firmly to close. Place the sensor in the intended location, ensuring that the metal probes on the bottom will make contact with water in the event of a leak.

Step 4: Complete Setup Online

Visit meshify.com/activate to complete the setup and configure alert recipients.


FAQ & Troubleshooting

accordion toggle Where should I install my sensor?


accordion toggle What should I do if my sensor has a red light on it?


accordion toggle My sensor is beeping, what does that mean?


accordion toggle My sensor detected a leak, will it still work?


accordion toggle How do I change who gets alerts for my sensor?


accordion toggle How long does the battery last?


accordion toggle The instructions say it uses a "Cellular Network". Do I need a cellular plan for the sensor?